Normalise Filter Plugin

The flir-filter-normalise plugin allows the user to normalise the timestamps of all readings that pass through the filter.

When adding a normalise filter to either the south or north, via the Add Application option of the user interface, a configuration page for the filter will be shown as below;

Click on the Enabled option and then click on Done to add the filter.

See Also

flir-filter-ADM_LD_prediction - Filter to detect whether a large discharge is required for a centrifuge

flir-filter-asset - A FLIR Bridge processing filter that is used to block or allow certain assets to pass onwards in the data stream

flir-filter-change - A FLIR Bridge processing filter plugin that only forwards data that changes by more than a configurable amount

flir-filter-delta - A FLIR Bridge processing filter plugin that removes duplicates from the stream of data and only forwards new values that differ from previous values by more than a given tolerance

flir-filter-enumeration - A filter to map between symbolic names and numeric values in a datapoint.

flir-filter-expression - A FLIR Bridge processing filter plugin that applies a user define formula to the data as it passes through the filter

flir-filter-fft - A FLIR Bridge processing filter plugin that calculates a Fast Fourier Transform across sensor data

flir-filter-log - A FLIR Bridge filter that converts the readings data to a logarithmic scale. This is the example filter used in the plugin developers guide.

flir-filter-metadata - A FLIR Bridge processing filter plugin that adds metadata to the readings in the data stream

flir-filter-python35 - A FLIR Bridge processing filter that allows Python 3 code to be run on each sensor value.

flir-filter-rate - A FLIR Bridge processing filter plugin that sends reduced rate data until an expression triggers sending full rate data

flir-filter-rename - A FLIR Bridge processing filter that is used to modify the name of an asset, datapoint or both.

flir-filter-rms - A FLIR Bridge processing filter plugin that calculates RMS value for sensor data

flir-filter-scale-set - A FLIR Bridge processing filter plugin that applies a set of sale factors to the data

flir-filter-specgram - FLIR Bridge filter to generate spectrogram images for vibration data

flir-filter-statistics - Generic statistics filter for FLIR Bridge data that supports the generation of mean, mode, median, minimum, maximum, standard deviation and variance.

flir-filter-vibration_features - A filter plugin that takes a stream of vibration data and generates a set of features that characterise that data

flir-south-Expression - A FLIR Bridge south plugin that uses a user define expression to generate data